Solutions by market

Restaurants

The exhaust hood sets the ventilation rate and the dining room pays the latent bill. Viking OA conditions make-up air to a supply dewpoint as low as 43°F, interlocked to the hood, so the kitchen stays negative, the dining room stays dry and the rooftop units carry sensible load only.
The challenge

The challenge in this building type

A kitchen hood moves more air than any other device in the building, and code requires that air to be replaced. When the make-up arrives untempered or heat-only, the dining room receives the outdoor dewpoint through the pass, and a packaged rooftop unit rated at 80°F DB / 67°F WB cannot hold it.

The hood sets the airflow

Make-up air must track hood exhaust, on hood status or a demand-controlled kitchen ventilation speed signal. A fixed-speed make-up unit is wrong at every point except one.

Humid make-up reaches the dining room

Untempered or heat-only make-up air pushes outdoor dewpoint through the pass on every summer service. The rooftop units cycle on temperature and the room runs humid.

Pressure cascade

Kitchen slightly negative to the dining room, dining room positive to outdoors. Lose it and grease and odor migrate, doors stand open and infiltration bypasses the dewpoint control.

A small, crowded, dirty roof

Hood exhaust fans, make-up air, rooftop units and grease duct on a deck that loads filters faster than any other and gets reroofed on a franchise cycle.

Systems

Recommended systems

The KCC equipment that fits this building type, and the roof interface it lands on.

PRIMARY RECOMMENDATION

Viking OA

Make-up air at a supply dewpoint as low as 43°F with modulating hot-gas reheat, VFD supply fan interlocked to the hood, dining-room DCV on CO2. Heat-only configurations across the line for kitchen make-up where dehumidified air is not required. Corrosive-environment package with eco-coated coils.
PAIRED SYSTEM

Viking HA

The mixed-air platform for dining rooms and bars where partial outdoor air and a moderate latent load call for the same cabinet and controls as the make-up unit.
ROOF INTERFACE

Curbs & adapters

Curb adapters for rooftop unit replacement on existing openings, structural curbs and equipment supports for a crowded deck. One lift, one vendor, details in IOM-A001.
Codes & Compliance

Codes & compliance

IMC §508 / ASHRAE 154

Kitchen make-up air interlocked to hood exhaust and conditioned at the unit; pressure cascade held by fan reset.

ASHRAE 62.1

Dining and kitchen ventilation rates delivered at a controlled state with demand-controlled ventilation reset.

ASHRAE 90.1 / IECC

Supports demand-controlled kitchen ventilation and transfer-air strategies; engineered to exceed part-load (ISMRE2) benchmarks.

AHRI 920

Certified DX-DOAS performance under ASHRAE SSPC 198, the method of test KCC engineers helped write.

PROJECT PROOF
Named project, named outcome

One-line result with a number in it. Every vertical page carries at least one installed-performance proof point.

FAQ

Frequently asked questions

What is a restaurant makeup air unit?

A unit that replaces the air removed by the kitchen exhaust hood, as required by IMC Section 508. Viking OA replaces it with conditioned air, held to a supply dewpoint as low as 43°F and interlocked to the hood, so the building pressure balance holds and the dining room does not receive the kitchen’s outdoor air.
Where it reaches the dining room, yes. Make-up air that is only heated or untempered carries the outdoor dewpoint into the building, and rooftop units selected for sensible load cannot remove it. Where make-up serves the kitchen only, heat-only Viking OA configurations are available.
On hood status or from a demand-controlled kitchen ventilation speed signal, the VFD supply fan resets so the kitchen stays slightly negative to the dining room through every service. The sequence is configured at the unit, with points available to the building automation system.
Yes. A cleanable 2-inch aluminum mesh screen at the intake extends final-filter life on a roof that loads filters quickly, and a corrosive-environment package with eco-coated coils or stainless interiors is available for coastal and grease-laden sites.
TALK TO KCC

One call to a rep who answers.

Hood interlock strategy, heat-only make-up selections and corrosive-site packages are reviewed by KCC Applications Engineering with your local rep. One call.